DRIVETRAIN COMPONENTS
3
2
Figure 14-27 Rear Wheel Bearing
Rear Wheel Bearing Installation
1. Clean inside axle tube where new bearing will sit and lightly lubricate the bore with anti-seize compound.
2. Using an appropriate sized bearing driver that fits the outer race, drive in new bearing until fully seated.
3. Install the retaining ring.
4. Clean axle shaft and carefully install axle tube to avoid damaging new seals. See Rear Differential and
Axle Shaft Installation on page 14-20.
2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
1
FRONT
OF VEHICLE
Rear Differential and Axle Shafts
Page 14-21
14