Club Car 2007 Carryall 295 Maintenance And Service Manual page 371

KAWASAKI GASOLINE ENGINE, MUFFLER, FUEL SYSTEM, AND CLUTCHES
4
5
AIR INTAKE HOSE NOT
SHOWN FOR CLARITY
Figure 13a-16 Accelerator Cable at Engine
8. Remove the accelerator cable from the plastic retaining clips under the passenger side of the frame. Pull
the cable at the dashboard to remove it from the engine compartment. See following NOTE.
NOTE: Tie a nylon cord to each end of the cable before removing it from the vehicle. Allow the cord to
travel from the attachment points and under the frame. The routed cord can then be used during
installation.
Accelerator Cable Installation
NOTE: When the accelerator cable is replaced, the high-speed RPM must be adjusted. See High-Speed
RPM Adjustment on page 13a-22.
1. Feed the pedal end and governor end of the accelerator cable up into place from under the vehicle on
the passenger side. See following NOTE.
NOTE: Tie the nylon cord routed during removal to the engine end of the cable. Pull the nylon cord to help
feed the cable back through the instrument panel area and engine compartment.
2. Secure the cable to the plastic retaining clips under the passenger side of the frame.
3. Connect the accelerator cable to the pedal.
3.1. Insert the Z-shaped end of cable (1) into the hole in the pedal (Figure 13a-17, Page 13a-20).
3.2. Secure the retention clip (2) at the pedal bracket (Figure 13a-15, Page 13a-18).
4. Connect the accelerator cable (3) to the accelerator linkage pin (8) on the engine (Figure 13a-16,
Page 13a-19).
4.1. Secure the cable sheath strain relief (4) to the bracket (5).
4.2. Secure the cable ring end (7) with the E-clip (6).
2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
3
6
7
8
13A
Engine Control Linkages
Page 13a-19