Table of Contents
Advertisement
Bracket
Bracket
6) Adjustment of Throttle Cable
1.
Check position of cable on low speed side and high
speed side.
2.
Set throttle grip to the slowest position, and fully pull
choke knob to close choke valve.
Adjust lock nut 1 while applying tension to outer wire by
3.
pulling it with a hand to fix low speed side wire.
The wire is in proper state if pushing inner wire at
the center makes deflection of about 1 mm.
4.
Repeat above steps for high speed side wire, and fix it.
5.
Return choke knob to the original position to fully open
choke valve.
To confirm the slowest position of throttle grip, check gap
between projection of throttle drum and dent of opener
section. The gap is acceptable if it is in the range
between 0.5 mm and 1 mm.
Repeat steps 2. to 4. if necessary.
7-20
1
4st 4/5/6 2020
Advertisement
Table of Contents
