Delete Snmp Host; Show Snmp Host - D-Link DGS-1210/ME series Reference Manual

delete snmp host

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete an SNMP host entry:
DGS-1210-28P/ME:5# delete snmp host 10.90.90.22
Command: delete snmp host 10.90.90.22
Success.
DGS-1210-28P/ME:5#

show snmp host

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the currently configured SNMP hosts on the Switch:
DGS-1210-28P/ME:5# show snmp host
Command: show snmp host
SNMP Host Table
(Maximum Entries : 10)
Host IP Address
------------------------
10.90.90.22
Total Entries : 1
DGS-1210-28P/ME:5#
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
To remove a recipient of SNMP traps generated by the Switch's
SNMP agent.
delete snmp host <ipaddr>
The delete snmp host command deletes a recipient of SNMP traps
generated by the Switch's SNMP agent.
<ipaddr> − The IP address of a remote SNMP manager that
receives SNMP traps generated by the Switch's SNMP agent.
Only Administrator-level users can issue this command.
To display the recipient of SNMP traps generated by the Switch's
SNMP agent.
show snmp host {<ipaddr>}
The show snmp host command is used to display the IP addresses
and configuration information of remote SNMP managers that are
DGSignated as recipients of SNMP traps generated by the Switch's
SNMP agent.
<ipaddr> − The IP address of a remote SNMP manager that
receives SNMP traps generated by the Switch's SNMP agent.
None.
SNMP Version
---------------------
V3-NoAuthNoPriv
Community Name/SNMPv3 User Name
-------------------------------------------------------
dlink
92