Show Stp Ports; Show Stp Instance_Id - D-Link DGS-3100 Series Cli Manual

DGS-3100 Gigabit Ethernet Switch Manual

show stp ports

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show stp ports 1 through 9
DGS3100# show
MSTP Po
---------------------------------
Port Index : 1:9,Port STP enabled
External PathCost : Auto/20
Msti
-------- -
0
DGS3100#

show stp instance_id

Purpose
Syntax
Description
Parameters
Forward Dela y
M ax Age
TX Hold Co unt
Forwarding BPDU
DGS3100#
To display the Switch's current instance_id configuration.
show stp ports <portlist>}
The show stp ports command displays the STP Instance Settings
and STP Instance Operational Status currently implemented on the
Switch.
<portlist> − A port or a range of ports to be viewed.
specified by listing the lowest switch number and the beginning port
number on that switch, separated by a colon. Then the highest
switch number, and the highest port number of the range
separated by a colon) are specified. The beginning and end of the
port list range are separated by a dash. For example, 1:3 specifies
switch number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-
2:4 specifies all of the ports between switch 1, port 3 and switch 2,
port 4 − in numerical order.
None.
on switch one:
stp ports 1:9
rt Inform ation
Designated Bridge
--------------- ------------------ ------------------------- ----- ---------------- ----------
8000 00:23:27:26:46:00
To display the Switch's STP instance configuration
sh ow stp instance_id <value 0-15>}
The show stp instance_id command displays the Switch's current
STP Instance Settings and the STP Instance Operational Status.
<value 0-15> - The value of the previously configured instance_id on
: 15
: 20
: 3
: Enabled
0000,Edge Port : No /No,P2P : Auto /Yes
Internal PathCost Prio Status
200000
64
The port list is
Role
128 Disabled Disabled
(also