Rear Wheels And Brakes - Toro Multi Pro 1200 Service Manual

Rear Wheels and Brakes

2
18
14
RIGHT
FRONT
1. Lug nut (5 used per wheel)
2. Flange head screw
3. Wheel assembly
4. Brake drum
5. Stub axle
6. Lock washer (5 used per wheel)
7. Drive stud (5 used per wheel)
Removal (Fig. 6)
1. Park machine on a level surface, stop engine and re-
move key from the ignition switch.
2. Chock front wheels. Raise rear wheel using a jack or
hoist (see Jacking Instructions in Chapter 1 -- Safety).
Support raised machine with jack stands.
3. Loosen and remove lug nuts that secure rear wheel.
Remove rear wheel.
4. Loosen set screw on parking brake control lever
knob (Fig. 7). Turn knob on parking brake lever counter-
clockwise all the way to loosen brake cables.
5. To remove brake drum, it may be necessary to back
off parking brake adjuster. To back off adjuster, rotate
brake drum until access hole lines up with star wheel.
Use a hooked piece of wire to pull pawl away from star
wheel, then turn star wheel. Pull brake drum from ma-
chine.
Chassis
200 to 250 in- -lb
16
(22.6 to 28.2 N- -m)
15
19
13
11
9
8
Loctite #271
8. Cap screw (4 used per wheel)
9. Lock washer (4 used per wheel)
10. Brake assembly
11. Brake cable clip
12. Axle housing assembly
13. Parking brake cable
Page 8 - - 10
40 to 60 ft- -lb
(55 to 81 N- -m)
Loctite #271
12
10
7
5
3
Figure 6
1. Parking brake lever
220 to 225 ft- -lb
(299 to 305 N- -m)
55 to 65 ft- -lb
(75 to 88 N- -m)
6
4
1
14. End yoke
15. Yoke strap (2 used per yoke)
16. Bolt (4 used per yoke)
17. Flange lock nut
18. Flat washer
19. Flange head screw (3 per housing)
2
1
Figure 7
2. Set screw
Multi Pro 1200/1250
17