Toro Multi Pro 1200 Service Manual page 62

2. Install spacer (item 3) on drive shaft. Then install new
seal (item 2) (see Shaft Seal Replacement above) and
secure with retaining ring (item 1).
3. Install woodruff key (item 13), then apply clean Dex-
ron III ATF to drive gear (item 20) and install to drive
shaft.
4. Install one crescent ring to idler shaft (item 21), then
install idler gear (item 19) and second crescent ring. Ap-
ply clean Dexron III ATF to gear and idler shaft assem-
bly, then install into stator maintaining the original timing
and locations.
Hydraulic System
5. Install new gasket (item 22) onto stator. Use same
color gasket as the removed gasket.
6. Install dowel pins (item 23). Assemble gear housing
to stator using the matchmark made during disassem-
bly. Install screws and tighten in a crossing pattern from
114 to 150 in- -lb (13 to 17 N- -m).
7. Install relief valve (see Relief Valve Service above).
8. Place a small amount of Dexron III ATF in pump inlet
and rotate pump one revolution. If binding is noted, dis-
assemble pump and check for assembly problems.
Page 4 - - 26 Multi Pro 1200/1250