Transaxle Assembly - Toro Multi Pro 1200 Service Manual

Transaxle Assembly

NOTE: Item numbers in figures are shown in reverse
order of assembly; for example, when reassembling,
install item 1 last.
IMPORTANT: Be careful not to damage mating sur-
faces when removing gasket material.
1. Clean gasket material from all transaxle mating sur-
faces before reassembling. Make sure all parts are
clean and free of dirt and dust.
2. Assemble differential carrier (L.H. axle shaft) assem-
bly (Fig. 69):
A. Apply multi--purpose grease on new oil seal (item
7) and install seal into differential carrier (item 8).
B. Use a press to install bearing (item 6) onto L.H.
axle shaft (item 3).
C. Install washer (item 5) and retaining ring (item 4)
onto L.H. axle shaft. Make sure that retaining ring is
fully seated in axle groove.
D. Install L.H. axle shaft assembly into carrier.
E. Install retaining ring (item 2) into groove in carrier.
Make sure that retaining ring is fully seated in carrier
groove.
F. Apply multi--purpose grease onto O--ring (item 1)
and install O--ring onto carrier.
3. Assemble R.H. axle shaft (Fig. 69):
A. Apply multi--purpose grease on oil seal (item 5)
and install seal into seal cover (item 7).
B. Use a press to install bearing (item 4) onto R.H.
axle shaft.
C. Install washer (item 3) and retaining ring (item 2)
onto R.H. axle shaft. Make sure that retaining ring is
fully seated in axle groove.
D. Insert washer (item 6) into seal cover.
E. Install R.H. axle shaft assembly into seal cover.
Drive Train
1
2
5
7
R.H. AXLE SHAFT
Page 7 - - 44
L.H. AXLE SHAFT
4 6
7
3
Figure 69
1
6
5
4
Figure 70
Multi Pro 1200/1250
8
3
2