Front Brake Service - Toro Multi Pro 1200 Service Manual

Front Brake Service

3
2
110 to 120 in- -lb
(12.4 to 13.6 N- -m)
1. Flange head screw
2. Cap screw (2 used per wheel)
3. Flat washer (2 used per wheel)
4. Lock washer
5. Brake backing plate
Disassembly (Fig. 5)
1. Remove front wheel and brake hub/drum and, if nec-
essary, remove brake assembly from machine (see
Front Wheels and Brakes in this section).
CAUTION
Be careful when removing springs from brake
shoes. The springs are under heavy tension and
may cause personal injury.
2. Remove upper and lower springs from brake shoes.
3. Remove shoe hold down cups and springs that se-
cure the brake shoes to the backing plate.
Chassis
1
110 to 120 in- -lb
(12.4 to 13.6 N- -m)
4
7
8
6
10
6. Belleville washer
7. Dust cover
8. Adjuster lever
9. Wheel cylinder
5
8
6
11
13
Figure 5
4. Remove brake shoes from backing plate.
5. If brake assembly is still on machine and wheel cylin-
der removal is necessary:
A. Clean hydraulic brake line area of wheel cylinder
to prevent contamination.
B. Loosen and remove banjo bolt from wheel cylin-
der and brake line. Locate and retrieve two (2) wash-
ers from brake line fitting. Cap brake line and position
it away from brake assembly.
C. Remove two (2) flange head screws that secure
wheel cylinder to backing plate. Remove wheel cylin-
der from backing plate.
Page 8 - - 8
10
9
12
10. Brake shoe
11. Upper spring
12. Lower spring
13. Shoe hold down cup and spring
Multi Pro 1200/1250
13