Jacking Instructions; Safety And Instruction Decals - Toro Multi Pro 1200 Service Manual

Jacking Instructions

CAUTION
When changing attachments, tires or perform-
ing other service, use appropriate jacks and
supports. Make sure machine is parked on a sol-
id, level surface such as a concrete floor. Prior
to raising machine, remove any attachments
that may interfere with the safe and proper rais-
ing of the machine. Always chock or block
wheels. Use appropriate jack stands to support
the raised machine. If the machine is not proper-
ly supported by jack stands, the machine may
move or fall, which may result in personal inju-
ry.
IMPORTANT: Before raising the sprayer, it is rec-
ommended to empty the spray tank. If the spray
tank is not emptied, consider the extra weight of
spray tank contents when choosing appropriate
jacks, hoists and jack stands for raising and sup-
porting the machine.
Jacking the Front End
1. Set parking brake and chock both rear tires to pre-
vent the machine from moving.
2. Position jack securely under the A--arms, just to the
inside of the front tire (Fig. 1).
3. Jack front of machine off the ground.
4. Position jack stands under the A--arms as close to
the wheel as possible to support the machine.
Jacking the Rear End
1. Set parking brake and chock both front tires to pre-
vent the machine from moving.
2. Place jack securely under the rear most frame sup-
ports between the angle welds (Fig. 2).
3. Jack rear of machine off the ground.
4. Position jack stands under the frame to support the
machine.

Safety and Instruction Decals

Numerous safety and instruction decals are affixed to
the Multi Pro 1200 and Multi Pro 1250. If any decal be-
comes illegible or damaged, install a new decal. Decal
part numbers are listed in your Parts Catalog. Order re-
placement decals from your Authorized Toro Distributor.
Safety Page 1 - - 4
1 1
Figure 1
1. Front jacking points
1
1
Figure 2
1. Rear jacking points
Multi Pro 1200/1250