Toro Multi Pro 1200 Service Manual page 210

8. Assemble reduction shaft:
A. Apply moly disulfide grease to thrust washer
(item 16) and two (2) needle bearings (item 15).
Install washer, needle bearings and 47T gear (item
14) onto reduction shaft (item 3). Oil groove on wash-
er must face the gear.
B. Apply Dexron III ATF oil on cone face of gear
(item 14). Install synchro ring (item 13) onto gear.
C. Insert key (item 12) into reduction shaft slot.
D. Install synchro hub sub--assembly (item 11).
E. Install retaining ring (item 10).
F. Insert needle bearing (item 9) into 40T gear (item
8). Slide gear and bearing assembly onto shaft.
G. Install thrust washer (item 7). Oil groove on wash-
er must face the gear.
H. Use a press to install bearing (item 6) onto shaft.
I. Install 32T gear (item 5), collar (item 4) and 25T
gear (item 2) onto shaft.
J. Use a press to install bearing (item 1) onto shaft.
9. Assemble reverse shaft:
A. Install 33T gear (item 2) onto reverse shaft (item
4).
B. Use a press to install bearings (item 3 and 1).
Drive Train
1
2
3
3
5
4
2
1
3
Page 7 - - 48
5 13
14 12
4
16
15
11
Figure 80
10
11
14
15
12
13
16
Figure 81
4
Figure 82
Multi Pro 1200/1250
7
10
8
6
9
6
9
8
7
13
1
2