Toro Multi Pro 1200 Service Manual page 211

10.Assemble main shaft:
A. Install 20T gear (item 17) and retaining ring (item
16).
B. Install 14T gear (item 15).
C. Use a press to install bearing (item 14) onto shaft.
D. Apply moly disulfide grease onto thrust washer
(item 13) and two (2) needle bearings (item 12).
Install washer and needle bearings onto main shaft.
Oil groove on washer must face the gear.
E. Install 22T gear (item 11) and retaining ring (item
10).
F. Apply Dexron III ATF oil on cone face of gear
(item 11). Install synchro ring (item 6) onto gear.
G. Insert key (item 9) into main shaft slot.
H. Install synchro hub sub--assembly (item 8).
I. Install retaining ring (item 7).
J. Apply Dexron III ATF oil to cone face of 36T gear
(item 4). Install synchro ring (item 6) onto gear.
K. Apply moly disulfide grease onto two (2) needle
bearings (item 5). Insert needle bearings into gear
(item 4).
L. Install gear (item 4) with synchro ring and needle
bearings onto main shaft.
M. Apply moly disulfide grease to thrust washer
(item 3). Install washer and snap ring (item 2) to
shaft. Oil groove on washer must face the gear.
N. Use a press to install bearing (item 1) onto shaft.
Multi Pro 1200/1250
4
3
1
18
5
2
4
3
5
2
1
6
10
7
Page 7 - - 49
7
8
10
13
16
9
17
12
15
6
11
Figure 83
8
16
17
6
9
18
12
13
11
Figure 84
Drive Train
14
14
15