Toro Multi Pro 1200 Service Manual page 56

Steering Pump Drive Belt
12
Loctite #242
10
Antiseize
Lubricant
FRONT
LEFT
1. Drive clutch
2. Pump drive pulley
3. Pump pulley
4. Cap screw (4 used)
5. Steering pump bracket
6. Steering pump
Steering Pump Drive Belt Removal (Fig. 18)
1. Park the machine on a level surface, apply parking
brake and stop engine. Remove key from the ignition
switch.
2. Remove CVT drive belt (see CVT Drive Belt Service
in Service and Repairs Section of Chapter 7 -- Drive
Train).
3. From under left side of machine, locate and loosen
two (2) flange head screws that secure steering pump
bracket to engine mounting plate.
4. Slide pump and pump bracket toward engine crank-
shaft to allow steering pump drive belt to be removed
from pulleys.
Hydraulic System
9
2
3
4
5
7. Flange head screw (2 used)
8. Flange nut (4 used)
9. Steering pump drive belt
10. Set screw (2 used)
11. Engine mounting plate
Page 4 - - 20
13
14
1
8
6
16
Figure 18
Steering Pump Drive Belt Installation (Fig. 18)
1. Install steering pump drive belt to pulleys.
2. Adjust steering pump belt tension (see Operator's
Manual).
3. Install CVT drive belt (see CVT Drive Belt Service in
Service and Repairs Section of Chapter 7 -- Drive Train).
15
11
7
12. Engine
13. CVT drive belt
14. Driven clutch
15. Pump drive gearbox
16. Hydraulic fitting (suction)
Multi Pro 1200/1250