Neutral Switch - Toro Multi Pro 1200 Service Manual

Neutral Switch

The neutral switch is attached to the shift lever assembly
(Fig. 11). The switch is a normally open proximity switch
that is closed when the shift lever is in the neutral posi-
tion. The neutral switch allows engine cranking/starting
only when the machine is in neutral.
Testing
1. Park machine on a level surface, stop engine, en-
gage parking brake and remove key from ignition
switch.
2. Locate neutral switch on the shift lever assembly. If
needed, remove air cleaner cover to ease access to
switch. Disconnect the wire harness connector from the
switch.
3. Check the continuity of the switch by connecting a
multimeter (ohms setting) across the connector termi-
nals.
4. With the shift lever in the neutral position, the neutral
switch should be closed (continuity).
5. Depress the brake pedal to allow the shift lever to
move. While watching the multimeter, move the shift le-
ver out of the neutral position. Continuity of the neutral
switch should be broken as the lever is moved and the
interlock switch opens.
6. If necessary, replace switch.
7. Connect the wire harness connector to the switch.
8. If removed, install air cleaner cover.
Electrical System
1. Shift lever
2. Sensing tab
Page 5 - - 10
1
2
3
4
Figure 11
3. Shifter bracket
4. Neutral switch
Multi Pro 1200/1250