Toro Multi Pro 1200 Service Manual page 203

5. Inspect hub, shifter, synchro keys and synchro
springs:
A. Inspect hub for worn or damaged spline.
B. Inspect shifter for chipping or damaged chamfer.
C. Inspect synchro keys for wear or damage.
D. Inspect synchro springs for wear or damage.
E. The shifter should move freely on the hub.
F. Measure the clearance between shifter groove
and fork. Replace shift fork if the clearance exceeds
0.039" (1.0 mm).
6. Inspect main shaft:
A. Inspect main shaft for worn or damaged surfaces.
If O.D. of needle bearing surface is less than 0.864"
(21.95 mm), replace the main shaft.
B. Inspect lip portion of oil seal for wear or damage.
C. Inspect main shaft input spline for wear or dam-
age.
IMPORTANT: The center plate has one (1) tabbed
shim (item 4) with three (3) tabless shims (item 2)
(Fig. 63).
7. Inspect retaining ring (item 3) and shims (items 2 and
4) for damage (Fig. 63). Replace all parts if any compo-
nent is cracked or broken.
Multi Pro 1200/1250
INPUT SPLINE
3
1
Page 7 - - 41
Figure 61
NEEDLE BEARINGS
OIL SEAL AREA
Figure 62
2
Figure 63
Drive Train
4