Toro Multi Pro 1200 Service Manual page 198

22.Disassemble reduction shaft assembly:
A. Use a bearing puller to remove bearing (item 1)
from reduction shaft.
B. Remove 25T gear (item 2), collar (item 4) and
32T gear (item 5).
C. Use a bearing puller to remove bearing (item 6).
D. Remove thrust washer (item 7), 40T gear (item 8)
and needle bearing (item 9).
E. Remove retaining ring (item 10).
F. Remove synchro shifter (item 11) together with
springs, hub and three (3) keys.
G. Remove key (item 12) from reduction shaft.
H. Remove synchro ring (item 13) from 47T gear
(item 14).
I. Remove 47T gear (item 14), needle bearings
(item 15) and thrust washer (item 16). Inspect needle
bearings and replace if necessary. Measure thick-
ness of thrust washer. Replace thrust washer if thick-
ness is less than 0.0709" (1.8 mm).
Drive Train
1
2
3
3
5
4
2
1
Page 7 - - 36
5 12
13
14
4
16
15
11
Figure 49
10
11
14
15
12
13
16
Figure 50
Multi Pro 1200/1250
7
10
8
6
9
6
9
8
7
13