Toro Multi Pro 1200 Service Manual page 31

6. Remove accelerator cable from engine (Figs. 15 and
16).
A. Slide the sleeve back on the cable ball joint and lift
accelerator cable from the ball stud.
B. Loosen one of the two cable jam nuts that se-
cures accelerator cable to control bracket.
C. Remove accelerator cable from the engine speed
control bracket and position away from the engine.
7. Remove choke cable from the engine speed control
bracket (Figs. 15 and 16).
8. Gaining access from under operator seat, loosen
two (2) flange head screws and flange nuts that secure
oil filter adapter to right hand frame rail (Fig. 17). Slide
adapter with oil filter away from frame.
9. Disconnect engine electrical connections (Fig. 18).
Position unplugged wires away from engine.
A. Unplug engine wire harness from machine wire
harness.
B. Remove nut on starter solenoid stud. Remove
fusible link connector and positive (+) battery cable
from solenoid stud.
C. Remove flange head screw, lock washer and nut
under starter motor that secures engine, wire har-
ness ground connection and negative (--) cable to
engine mounting plate.
10.Remove CVT drive belt from the drive clutch (see
CVT Drive Belt Service in the Service and Repairs Sec-
tion of Chapter 7 -- Drive Train).
11. Loosen hydraulic steering pump and remove pump
drive belt from pulleys.
12.Loosen and remove three (3) remaining flange head
screws and flange nuts that secure engine to engine
mounting plate.
IMPORTANT: Make sure to not damage the engine,
fuel hoses, hydraulic lines, electrical harness or
other parts while removing the engine.
13.Carefully lift engine from mounting plate and ma-
chine.
14.If needed, remove drive clutch from engine crank-
shaft (see Drive Clutch in the Service and Repairs Sec-
tion of Chapter 7 -- Drive Train).
15.If needed, loosen set screws and remove steering
pump pulley from engine crankshaft. Locate and re-
trieve key.
Multi Pro 1200/1250
2
1. Accelerator cable
2. Cable ball joint
3. Cable jam nut
Antiseize
Lubricant
6
6
7
8
1. Accelerator cable
2. Cable ball joint
3. Choke cable
4. Choke cable clamp
2
1. Oil filter adapter
Page 3 - - 15
4
1
3
5
Figure 15
4. Choke cable
5. Choke cable clamp
5
4
3
2
1
Figure 16
5. Cap screw
6. Ball joint jam nut
7. Speed control bracket
8. Hex nut
1
Figure 17
2. RH frame rail
Kohler Gasoline Engine