Bleed Brake System - Toro Multi Pro 1200 Service Manual

Bleed Brake System

After loosening or removing any hydraulic brake compo-
nent, the brake system should be bled to insure proper
brake operation.
NOTE: A power/vacuum brake bleeding tool will pro-
vide faster and more effective brake bleeding than
manual bleeding.
1. Connect a suitable transparent hose to bleeder valve
on wheel cylinder and submerge other end of hose in a
glass container partially filled with clean brake fluid.
2. Have a second person pump brake pedal several
times, then hold pedal down firmly.
3. With pedal firmly depressed, open bleeder valve of
wheel cylinder until pedal fades to floor. Close bleeder
valve before releasing pedal.
Multi Pro 1200/1250
4. Repeat procedure until a continuous flow of brake
fluid, with no air bubbles, is released from bleeder valve.
Make sure fluid level is maintained in brake fluid res-
ervoir at all times.
5. Repeat steps 1 to 4 for other wheel cylinders.
After servicing the brakes, always check brake
operation in a wide open, level area that is free of
other persons and obstructions.
6. After bleeding of brakes is completed, test vehicle to
make sure brakes are operating correctly and that brake
pedal is solid.
Page 8 - - 17
CAUTION
Chassis