Toro Multi Pro 1200 Service Manual page 26

Engine Mounting Plate Assembly
1
5
8
25
24
15
Antiseize
Lubricant
27
28
FRONT
LEFT
1. Engine
2. Pump pulley
3. Key
4. Drive clutch
5. Flange head screw (4 used)
6. Stepped washer
7. Cap screw
8. Lock washer
9. Flange nut (4 used)
10. Set screw (2 used)
NOTE: For easiest service access to the engine, re-
moval of the spray tank is recommended (see Spray
Tank Removal in the Service and Repairs section of
Chapter 6 -- Spray System). As an alternative, the en-
gine mounting plate can be lowered from the machine
to access the engine. The hydraulic hoses to the steer-
ing pump and the fuel hoses to the engine do not need
to be disconnected unless the mounting plate is to be
completely removed from the machine.
Kohler Gasoline Engine
Loctite #242
3
10
2
14
19
9
23
26
22
11. CVT drive belt
12. Driven clutch
13. Pump drive gearbox
14. Steering pump drive belt
15. Steering pump pulley
16. Hydraulic steering pump
17. Engine mounting plate
18. Engine support strap (2 used)
19. Machine frame
20. Cap screw (4 used)
11
12
4
6
Loctite #242
16
7
18
21
20
Figure 8
The engine, exhaust system and drive compo-
nents may be hot. To avoid possible burns, allow
all components to cool before working on the
engine mounting plate assembly.
Page 3 - - 10
13
40 to 45 ft- -lb
17
(55 to 61 N- -m)
21. Washer (4 used)
22. Engine mount assembly (4 used)
23. Flange nut (4 used)
24. Oil drain nipple
25. Oil drain elbow
26. Flange nut (4 used)
27. Flange head screw (4 used)
28. R- - clamp (3 used)
29. Transaxle driveshaft
CAUTION
Multi Pro 1200/1250
29