Toro Multi Pro 1200 Service Manual page 218

21.Install differential gear assembly (item 2) into trans-
axle case.
22.Insert two (2) dowel pins (item 1) into transaxle case.
23.Install side cover:
A. Thoroughly clean mating surfaces of transaxle
case and side cover. Apply silicone sealant onto mat-
ing surface of side cover.
B. Install side cover and secure with cap screws.
Torque cap screws from 18 to 22 ft- -lb (24.5 to 29.5
N- -m).
24.Install R.H. axle shaft assembly:
A. Thoroughly clean mating surface of transaxle
case and seal cover of R.H. axle shaft assembly. Ap-
ply silicone sealant onto mating surface of seal cov-
er.
B. Install axle shaft assembly (item 2) and secure
with cap screws. Torque cap screws (item 1) from 18
to 22 ft- -lb (24.5 to 29.5 N- -m).
Drive Train
1
1
2
Page 7 - - 56
2
Figure 100
18 to 22 ft- -lb
(24.5 to 29.5 N- -m)
NOTE: This
shaft not
Multi Pro
Figure 101
18 to 22 ft- -lb
(24.5 to 29.5 N- -m)
Figure 102
Multi Pro 1200/1250
1
used on