Toro Multi Pro 1200 Service Manual page 29

6. Install choke cable to engine and secure with cable
clamp (Figs. 9 and 10). Check choke cable adjustment
(see Adjust Choke Cable in the Adjustments Section of
this chapter).
7. Reconnect accelerator cable to engine (Figs. 9 and
10).
A. Position accelerator cable to the engine speed
control bracket.
B. Slide the sleeve back on the cable ball joint and
place cable ball joint on ball stud. Release the sleeve
so it slides over the stud to secure cable.
C. Tighten cable jam nuts that secure accelerator
cable to control bracket.
8. If fuel line was removed, route fuel line through R--
clamps on mounting plate. Connect fuel line to the fuel
pump and secure with clamp.
Multi Pro 1200/1250
9. Position oil filter adapter with oil filter to the right hand
frame rail. Install two (2) flange head screws and flange
nuts and secure oil filter adapter to machine (Fig. 11).
10.Reinstall the muffler section of the exhaust system
(see Exhaust System Installation in this section).
11. If hydraulic hoses were disconnected, make sure hy-
draulic hoses and pump ports are clean. Remove plugs
and caps from pump and hoses that were placed during
disassembly. Install hydraulic hoses to steering pump.
12.Check engine oil level and transaxle/hydraulic fluid
level (see Operator's Manual).
13.Connect positive (+) and then negative (--) battery
cables to the battery.
14.Check engine speed (see Adjust Engine Speed in
the Adjustments Section of this chapter).
Page 3 - - 13 Kohler Gasoline Engine