Toro Multi Pro 1200 Service Manual page 153

Removal (Fig. 57)
IMPORTANT: Make sure to remove and neutralize
chemicals from tank and spray components before
disassembly. Wear protective clothing, chemical re-
sistant gloves and eye protection during repair.
1. Park machine on a level surface, stop engine, en-
gage parking brake and remove key from the ignition
switch.
2. Drain spray tank (see Operator's Manual).
3. Label all hoses that are connected to spray tank fit-
tings to allow proper installation after repairs are com-
pleted. Loosen hose clamps and disconnect all hoses
from spray tank hosebarbs.
NOTE: A rubber spacer (item 12) is used between the
rear tank band and saddle on the right side of the ma-
chine.
4. Remove cap screws (item 17), hardened washers
(item 18) and flange nuts (item 21) that secure front and
rear tank bands (items 4 and 3) to saddles.
5. Remove front tank band from machine.
6. Carefully position rear tank band with attached
mounting bracket (item 13) and spray components
away from spray tank.
7. Raise spray tank assembly from machine.
8. Remove tank saddles from machine frame if neces-
sary.
Installation (Fig. 57)
1. Make sure that foam cushions on front and rear
saddles are in good condition. Install new cushions if
needed.
2. If tank saddles were removed from frame, position
saddles to frame and secure with flange head screws
and flange nuts.
3. Carefully lower spray tank assembly onto machine.
Multi Pro 1200/1250
4. Position tank bands to front and rear of tank.
NOTE: A rubber spacer (item 12) is used between the
rear tank band and saddle on the right side of the ma-
chine.
5. Install cap screws (item 17), hardened washers (item
18) and flange nuts (item 21) to secure front and rear
tank bands (items 4 and 3) to saddle. On RH rear tank
band, make sure that rubber spacer is placed between
the tank band and saddle.
6. Using labels placed during tank removal, correctly
connect hoses to spray tank fittings. Secure hoses with
hose clamps.
7. Make sure that drain valve is closed and secured to
sprayer with lynch pin.
8. After spray tank installation, make sure that spray
hoses do not contact any moving parts on machine.
9. Check spray tank for leaks. Repair all leaks before
returning the sprayer to service.
5
7
1. Spray tank
2. Spigot assembly
3. Cap
4. Fresh water tank
Page 6 - - 53
3
4
6
1
Figure 58
5. Cap
6. Rinse tank
7. Rubber pad
Spray System
2