Turret Bodies - Toro Multi Pro 1200 Service Manual

Turret Bodies

9
10
1
1
4
1. Turret body (single LH barb)
2. Tee fitting (1 used per boom section)
3. Hose clamp
4. Turret body (double hose barb)
Removal (Fig. 59)
IMPORTANT: Make sure to remove and neutralize
chemicals from spray components before disas-
sembly. Wear protective clothing, chemical resist-
ant gloves and eye protection during repair.
1. Park machine on a level surface, stop engine, en-
gage parking brake and remove key from the ignition
switch.
2. Loosen hose clamp(s) and remove supply hose(s)
from turret body.
3. Remove flange nut that secures turret body to mount
bracket. Remove turret body from machine.
Spray System
12
3
8
4
LEFT
BOOM
SUPPLY
5 1
4
5. Turret body (single RH barb)
6. Hose
7. Hose
8. Hose
Page 6 - - 54
11
7
2
3
CENTER
RIGHT
BOOM
BOOM
SUPPLY
SUPPLY
4
5 1
Figure 59
Installation (Fig. 59)
NOTE: The type of hose barb on turret body deter-
mines turret location on spray boom. Refer to Figure 59
for turret position on booms.
1. Position turret body clamp halves to spray boom and
turret body. Slide clamp halves together. Level turret and
tighten flange nut to secure turret body.
2. Install supply hose(s) to turret body. Tighten hose
clamp(s).
FRONT
RIGHT
6
3
5
4
4
5
9. Flange nut
10. Mount bracket
11. Boom frame
12. Pop rivet (2 used per bracket)
Multi Pro 1200/1250