Toro Multi Pro 1200 Service Manual page 133

Disassembly (Fig. 33)
1
IMPORTANT: Make sure to remove and neutralize
chemicals from spray components before disas-
sembly. Wear protective clothing, chemical resist-
ant gloves and eye protection during repair.
1. Remove pressure control valve from machine (see
Spray Control (Multi Pro 1200) in this section).
2. Disassemble pressure control valve using Figure 33
as a guide. Discard all removed O--rings.
Assembly (Fig. 33)
NOTE: Coat all O--rings with vegetable oil before instal-
lation to reduce the chance of damage during assembly.
1. Assemble pressure control valve using Figure 33 as
a guide. Replace all removed O--rings.
2. Install pressure control valve to machine (see Spray
Control (Multi Pro 1200) in this section).
FRONT
Figure 34
1. Pressure control valve
Multi Pro 1200/1250 Page 6 - - 33 Spray System