Toro Multi Pro 1200 Service Manual page 35

Disassembly
DANGER
Gasoline is flammable. Use caution when stor-
ing or handling it. Wipe up any spilled fuel be-
fore starting the engine.
1. Inspect carbon canister and attached hoses for dam-
age or obvious leaks. A damaged or leaking canister
should be replaced.
2. Remove EVAP components as needed using Figure
19 as a guide.
A. If check valve (item 7 in Fig. 19) is removed, note
direction of arrow on valve body for assembly pur-
poses.
B. If hoses are removed from the carbon canister,
note hose location for assembly purposes. Figure 20
identifies hose location.
Assembly
1. Install all removed components using Figure 19 as
a guide.
A. If check valve (item 7 in Fig. 19) was removed,
make sure that arrow on valve body points toward
engine.
B. Make sure that evaporative system fuel hoses
are not kinked after installation. Also, secure all
hoses with hose clamps.
Multi Pro 1200/1250
CARBON CANISTER CONNECTIONS
Page 3 - - 19 Rev. A
TO FUEL TANK VENT
TO CHECK VALVE
Figure 20
Kohler Gasoline Engine