Headlights - Toro Multi Pro 1200 Service Manual

Headlights

Headlight Removal (Fig. 39)
1. Park machine on a level surface, stop engine, en-
gage parking brake and remove key from ignition
switch.
2. Reach beneath dash and push headlight out of the
hood.
3. Remove screws attaching the wire harness to the
headlight.
4. Remove rubber seal from around the headlight. Dis-
card headlight.
Headlight Installation (Fig. 39)
1. Align notch on the inside of the seal with the notch on
the new headlight. Slide seal onto the headlight until the
seal is firmly in place.
2. Attach headlight to the wire harness using the pre-
viously removed screws.
NOTE: Applying soapy water to the outside of the seal
will aid in sliding the seal into the hood. Make sure to
thoroughly dry headlights before turning lights on.
3. Align notch on the outside of the seal with the notch
in the hood. Push headlight and seal into the hood until
it is firmly in place.
Electrical System
1. Rubber seal
2. Outside notch
Page 5 - - 24
2
1
Figure 39
3. Headlight
Multi Pro 1200/1250
3