Toro Multi Pro 1200 Service Manual page 196

15.To remove shift arms:
A. Loosen and remove lock nuts (item 3) that secure
shift arms (items 1 and 4). Remove flat washers (item
2) and shift arms.
B. Loosen and remove cap screws (item 5). Re-
move lock washers (item 6) and keeper plates (item
7).
C. Remove oil seals (item 8) from transaxle case.
D. Inspect shift arms and keeper plates for bending
or damage and replace if necessary.
16.Loosen five (5) cap screws (item 1) and remove nut
with washer (item 2). Separate P.T.O. cover (item 3) and
O--ring from transaxle case. Inspect P.T.O. cover for
cracks or damage and replace if necessary.
17.If necessary, remove oil cap (item 4) with O--ring from
transaxle case.
18.If necessary, remove air breather (item 5) from trans-
axle case.
19.If necessary, remove cap screw with lock washer
(item 1) and slide speed sensor (item 2) from upper cov-
er (item 4).
20.Loosen and remove cap screws (item 3) that secure
upper cover to transaxle case. Remove upper cover
(item 4) from case.
Drive Train
1
8
1. Shift arm (2- -3)
2. Flat washer
3. Lock nut
4. Shift arm lever (1- -R)
5
4
2
Page 7 - - 34
3
2
3
5
2
6
7
8
Figure 44
5. Cap screw
6. Lock washer
7. Keeper plate
8. Oil seal
2
Figure 45
4
1
3
Figure 46
Multi Pro 1200/1250
4
5
6
7
3
1