Toro Multi Pro 1200 Service Manual page 171

Transaxle (continued)
Symptom
Gears make clashing noise when shifting.
Transaxle sticks in gear.
Transaxle slips out of gear.
Overheating of transaxle.
Multi Pro 1200/1250
Possible Causes
Shifting too fast.
Excessive wear of transaxle synchro rings.
Excessive wear of differential side gear thrust wash-
ers and/or pinion gear washers.
Damaged transaxle synchro springs and/or keys.
Transaxle main gear needle bearings worn or dam-
aged.
Excessive wear of driveshaft(s).
Transaxle shift fork detent ball stuck.
Shift linkage damaged, loose or out of adjustment.
Transaxle sliding gears tight on shaft splines.
Transaxle synchro shift keys damaged.
Shift linkage out of adjustment.
Gear loose on transaxle shaft.
Transaxle gear teeth worn.
Excessive end play in transaxle gears.
Lack of spring pressure on transaxle shift fork det-
ent ball.
Badly worn transaxle bearings.
Oil level too high in transaxle.
Excessive hydraulic load (see Chapter 8 -- Hydraulic
System).
Page 7 - - 9 Drive Train