Stub Axle And Driveshaft - Toro Multi Pro 1200 Service Manual

Stub Axle and Driveshaft

21
18
22
20
19
2
15
14
RIGHT
FRONT
1. Lug nut (5 used per wheel)
2. Flange head screw
3. Wheel assembly
4. Brake drum
5. Stub axle
6. Lock washer (5 used per wheel)
7. Drive stud (5 used per wheel)
8. Cap screw (4 used per wheel)
Removal (Fig. 24)
1. Park machine on a level surface, stop engine and re-
move key from the ignition switch.
2. Chock front wheels. Raise rear wheel using a jack or
hoist (see Jacking Instructions in Chapter 1 -- Safety).
Support rear of machine with jack stands.
3. Loosen and remove lug nuts. Remove rear wheel.
Remove brake drum (see Rear Wheels and Brakes in
the Service and Repairs Section of Chapter 8 -- Chas-
sis).
NOTE: Loosening driveshaft at transaxle will allow eas-
ier driveshaft removal from end yoke.
Drive Train
200 to 250 in- -lb
(22.6 to 28.2 N- -m)
17
13
23
11
9
8
Loctite #271
9. Lock washer (4 used per wheel)
10. Brake assembly
11. Brake cable clip
12. Axle housing assembly
13. Flange head screw (3 used per wheel)
14. End yoke
15. Flat washer
16. Flange lock nut
Loctite #271
40 to 60 ft- -lb
(55 to 81 N- -m)
12
10
7
5
3
Figure 24
4. Remove the straps securing driveshaft bearing
cross to the end yoke, then disconnect driveshaft from
the end yoke.
5. Loosen flange lock nut that secures end yoke to stub
axle. Remove flange lock nut, flat washer and flange
head screw. Pull end yoke from stub axle.
6. Carefully slide stub axle from axle housing.
7. To remove driveshaft from transaxle, loosen and re-
move lock nuts, cap screws and hardened washers se-
curing driveshaft to splined axle shaft of transaxle. Slide
driveshaft outward and remove from transaxle.
Page 7 - - 24
220 to 225 ft- -lb
(299 to 305 N- -m)
Loctite #271
55 to 65 ft- -lb
(75 to 88 N- -m)
6
4
17. Yoke strap (2 used per yoke)
18. Bolt (4 used per yoke)
19. Driveshaft assembly
20. Lock nut (2 used per driveshaft)
21. Cap screw (2 used per driveshaft)
22. Hardened washer (2 per driveshaft)
23. Parking brake cable
Multi Pro 1200/1250
16
1