Toro Multi Pro 1200 Service Manual page 143

Disassembly (Fig. 47)
IMPORTANT: Make sure to remove and neutralize
chemicals from spray components before disas-
sembly. Wear protective clothing, chemical resist-
ant gloves and eye protection during repair.
1. Remove spray control assembly from machine and
separate boom valve manifold assembly from spray
control (see Spray Control Assembly (Multi Pro 1250)
Removal in this section).
2. Disassemble boom valve manifold assembly as
needed using Figure 47 as a guide. Discard all removed
O--rings and gaskets.
3. See Boom and Agitation Valve Motor Service in this
section for disassembly and assembly information of the
agitation valve motor.
Assembly (Fig. 47)
NOTE: Coat all O--rings with vegetable oil before instal-
lation to reduce the chance of damage during assembly.
1. Assemble boom valve manifold assembly using Fig-
ure 47 as a guide.
2. Attach boom valve manifold assembly to spray con-
trol and then install spray control assembly to machine
(see Spray Control Assembly (Multi Pro 1250) Installa-
tion in this section).
Multi Pro 1200/1250
1
1. Regulating valve
2. Flowmeter
3. LH boom valve motor
Page 6 - - 43
4
3
2
Figure 48
4. Center boom valve motor
5. RH boom valve motor
Spray System
5