Toro Multi Pro 1200 Service Manual page 123

Disassembly (Fig. 20)
IMPORTANT: Make sure to remove and neutralize
chemicals from tank and other components before
disassembly. Wear protective clothing, chemical re-
sistant gloves and eye protection during repair.
1. Park machine on a level surface, stop engine, en-
gage parking brake and remove key from the ignition
switch.
2. Drain spray tank (see Operator's Manual).
3. Label hoses to allow proper installation after repairs
are completed. Loosen hose clamps and remove hoses
from all hosebarbs that are to be disassembled.
4. Remove agitation components as required using
Figure 20 as a guide. Discard all removed O--rings and
gaskets.
Multi Pro 1200/1250
Assembly (Fig. 20)
NOTE: Coat all O--rings with vegetable oil before instal-
lation to reduce the chance of damage during assembly.
1. Install agitation components using Figure 20 as a
guide. Replace all removed O--rings and gaskets.
2. Using labels placed during disassembly, install
hoses to hosebarbs and secure with hose clamps.
3. Check spray system for leaks. Repair all leaks be-
fore returning the sprayer to service.
Page 6 - - 23 Spray System