Toro Multi Pro 1200 Service Manual page 65

Removal (Fig. 22)
1. Park the machine on a level surface, engage parking
brake and stop engine. Remove key from the ignition
switch.
2. Remove screws that secure dash panel to front hood
(Fig. 23). Carefully slide dash panel up steering column
to allow access to steering control valve.
CAUTION
Before disconnecting components or perform-
ing any work on hydraulic system, all pressure in
the system must be relieved by stopping the en-
gine and rotating the steering wheel in both
directions.
3. Label all hydraulic hoses for assembly purposes
(Fig. 24). Clean hydraulic hose ends prior to disconnect-
ing the hoses from the steering control valve.
4. Disconnect hydraulic hoses connected to the steer-
ing control valve. Allow hoses to drain into a suitable
container. Cap or plug openings of control valve and
hoses to prevent contamination.
5. Support steering control valve to prevent it from fal-
ling during removal.
6. Loosen and remove four (4) cap screws and lock
washers that secure steering column and steering con-
trol valve to machine frame.
7. Slide steering column from control valve. Remove
control valve from machine.
Installation (Fig. 22)
1. Position steering control valve to frame. Slide steer-
ing column to control valve. Secure steering column and
control valve to frame with four (4) cap screws and lock
washers.
2. Remove caps and plugs from disconnected hoses
and fittings.
3. Using labels placed during removal, connect hydrau-
lic hoses to steering control valve (Fig. 24). Tighten hose
connections (see Hydraulic Hose and Tube Installation
in the General Information section of this chapter).
4. Position dash panel to front hood and secure with re-
moved fasteners (Fig. 23).
Multi Pro 1200/1250
5. Check fluid level in transaxle and adjust as required
(see Operator's Manual).
6. After assembly is completed, operate steering cylin-
der to verify that hydraulic hoses and fittings are not con-
tacted by anything.
1
1. Steering wheel
3
4
1. T port (hose to oil filter)
2. L port (hose to rod end of steering cylinder)
3. P port (hose to steering pump)
4. R port (hose to barrel end of steering cylinder)
Page 4 - - 29
2
Figure 23
2. Dash panel
1
2
Figure 24
Hydraulic System