Toro Multi Pro 1200 Service Manual page 216

18.Measure countershaft end play. Rotate one of the
axle shafts back and forth to take up all back lash. Rotat-
ing the shaft in one direction will pull the shaft and bear-
ing away from the snap ring. Rotate axle shaft in this
direction, then measure space between the retaining
ring and shim (set) with a feeler gauge. Make sure shim
set is pressed against the bearing during the measure-
ment. End play should be 0.000" to 0.0039" (0.0 to 0.10
mm) (Fig. 95).
IMPORTANT: If end play is too great, replace shim/
shim set (item 2) with thicker shims to allow correct
end play.
19.Insert sealing cap (item 1) flush with face of center
plate. Make sure not to insert sealing cap too far. Pay
attention to direction of sealing cap.
Drive Train Page 7 - - 54
Figure 95
1
Figure 96
Multi Pro 1200/1250