Hour Meter; Headlight Switch - Toro Multi Pro 1200 Service Manual

Hour Meter

The hour meter is located on the control console next to
the operator seat.
Testing
1. Park machine on a level surface, stop engine, en-
gage parking brake and remove key from ignition
switch.
2. Remove console panel. Disconnect the harness
electrical connectors from the terminals on the hour
meter.
3. Connect the positive (+) terminal of a 12 VDC source
to the positive (+) terminal of the hour meter.
4. Connect the negative (--) terminal of the voltage
source to the other terminal of the hour meter.
5. The hour meter should move a 1/10 of an hour in six
(6) minutes.

Headlight Switch

The headlight switch is located on the control console
next to the operator seat (Fig. 13).
Testing
1. Park machine on a level surface, stop engine, en-
gage parking brake and remove key from ignition
switch.
2. Remove console panel, locate headlight switch and
unplug wire harness connector from switch.
3. The switch terminals are marked as shown in Figure
14. In the ON position, continuity should exist between
the two terminals. In the OFF position, there should be
no continuity between the switch terminals.
4. After testing, connect the harness connector to the
switch. Install console panel to machine.
Multi Pro 1200/1250
6. Disconnect voltage source from the hour meter.
7. Connect yellow/red harness wire to the positive (+)
terminal of the hour meter and black harness wire to the
other meter terminal. Install console panel.
1
2
1. Control console
BACK OF SWITCH
Page 5 - - 11
Figure 12
Figure 13
2. Headlight switch
Figure 14
Electrical System