Toro Multi Pro 1200 Service Manual page 219

25.Install L.H. axle shaft assembly:
A. Thoroughly clean mating surface of differential
carrier and side cover (item 2).
B. Insert selected shims (item 1) into housing of side
cover.
NOTE: The thickest shim should be installed
against the bearing.
C. Install axle shaft assembly and secure with cap
screws (item 1). Torque cap screws from 18 to 22 ft- -
lb (24.5 to 29.5 N- -m).
26.Measure backlash of ring gear through P.T.O. cover
opening on top of transaxle. Using a dial indicator, check
ring gear backlash in three equally spaced points. Back-
lash should be 0.0031" to 0.0071" (0.08 to 0.18 mm) and
must not vary more than 0.002" (0.05 mm) at the points
checked. If backlash is not in this range, replace shim
set in end of differential carrier:
A. If backlash is less than target range, decrease to-
tal thickness of shim set until correct backlash is
achieved.
B. If backlash exceeds the target range, increase to-
tal thickness of shim set until correct backlash is
achieved.
NOTE: The thickest shim should be installed
against the bearing.
Multi Pro 1200/1250
2
Page 7 - - 57
1
Figure 103
18 to 22 ft- -lb
(24.5 to 29.5 N- -m)
1
Figure 104
Figure 105
Drive Train