Adjusting The Parking Brake; Hydraulic System Maintenance; Checking The Transaxle/Hydraulic Fluid - Toro Multi Pro 1750 Operator's Manual

Adjusting the Parking
Brake
Service Interval: Every 200 hours—Check the
parking brake.
1. Remove the plastic grip.
2. Loosen the set screw securing the knob to the
parking-brake lever
Figure 48
1. Parking-brake lever
3. Rotate the knob until a force of 18 to 23 kg (40
to 50 lb) is required to actuate lever.
4. Tighten the set screw.
(Figure 48).
Hydraulic System
Maintenance
Checking the
Transaxle/Hydraulic Fluid
Service Interval: Every 200 hours
1. Position the sprayer on a level surface, engage
the parking brake, shut off the sprayer pump,
shut off the engine, and remove the key.
2. Remove the transaxle dipstick and wipe it with a
clean rag
g023036
1. Dipstick
Important:
other contaminants into the opening when
checking the transmission oil.
3. Insert the dipstick into the tube and make sure
that it is seated fully. Remove the dipstick and
check the oil level.
4. The transaxle fluid level should be at the top
of the flat portion of the dipstick. If it is not, fill
the reservoir with the appropriate fluid; refer to
Changing Transaxle/Hydraulic Fluid (page
5. Install the dipstick firmly in place.
51
(Figure 49).
Figure 49
2. Fill hole
Be very careful not to get dirt or
g002002
52).