Installing The Center Boom Section; Center-Boom Assembly; Bolt (3/8 X 1 Inch); Flanged Locknut (3/8 Inch) - Toro Multi Pro WM 41240 Operator's Manual

Important:
If any hoses or wiring on the
tank skid assembly are pinched or bent,
raise the assembly up, adjust its positioning,
and tie the items back.
7. Align the front mounting brackets with the
hold-down brackets installed in
Hold-down Brackets for the Tank Skid (page
8. Secure the hold down bracket of the tank skid
assembly to the bed bracket on the frame at
each side of the machine with a bolt (1/2 x 1-1/2
inches) and a locknut (1/2 inch) as shown in
Figure 26.
9. Torque the bolt and locknut to 91 to 113 N-m (67
to 83 ft-lb)
10. Repeat steps 7 through
tank skid and machine.
12
Installing the Center Boom
Section
Parts needed for this procedure:
1

Center-boom assembly

10

Bolt (3/8 x 1 inch)

10

Flanged locknut (3/8 inch)

2

Boom-transport cradle

4

Bolt (1/2 x 1-1/4 inches)

4

Flange nut (1/2 inch)

Assembling the Boom Transport
Cradles
1. Attach lifting equipment to the center boom
section and remove it from the shipping
container.
2. Align the boom transport cradles to the center
boom section (Figure
4 Installing the
9 at the other side of the
27).
17).
1. Boom-transport cradle
2. Bolts (3/8 x 1 inch)
3. Vertical holes (boom
center section)
3. Assemble the cradles to the boom section
(Figure 27
inch) and 6 flanged locknuts (3/8 inch).
1. Locknuts (3/8 inch)
4. Torque the bolts and nuts to 37 to 45 N-m (27
to 33 ft-lb).

Installing the Center Boom Section

to the Tank Skid
1. Start the machine, remove the bed support from
the lift cylinder and stow the support, lower the
tank skid, shutoff the machine, and remove the
key from the
2. Align the bottom hole in the section mounting
brackets of the center boom assembly with the
26
Figure 27
4. Horizontal hole (boom
center section)
5. Flanged locknut (3/8 inch)
and Figure 28) with 6 bolts (3/8 x 1
Figure 28
switch.
STARTER
g028458
g028459