Panasonic KX-TD500 System Reference Manual page 190

Programming
System Programming
"System-Operation (3/3)",
Operator 1
Operator 2
"System-Tenant",
Operator 1 (Tenant 2)
Operator 2 (Tenant 2)
Conditions
• Tenant Service
If tenant service is employed, each tenant (1 and
2) can have unique operator assignment
individually, that is, up to four operators can be
assigned to the system.
In this case, the operator assignment should be
arranged as follows.
Tenant 1
Operator 1 ATT
Operator 2 ATT
Operator 1 ATT
Operator 2 Ext.
Operator 1 Ext.
Operator 2 Ext.
The operator assignment can be done in the
system programming as follows.
(Tenant 1)
"System-Operation (3/3)", Operator 1 and
Operator 2.
(Tenant 2)
"System-Tenant", Operator 1 and Operator 2.
Reference
VT Dumb
11-C-4.00
10-D-1.03
11-C-5.00
10-D-2.00
Tenant 2
Ext.
Ext.
or
ATT
Ext.
or
ATT
ATT
3-B-10
• Invalid Operator Assignment
The following arrangement is invalid in the
operator assignment whether tenant service is
employed or not.
Operator 1 —
Operator 2 ATT
• Operator Call
The extension user can call the operator in the
system by dialing the feature number for
"Operator Call (General)" or "Operator Call
(Specific)".
For further information, refer to the following:
(PITS users)
Section 4-C-10.00 "Operator Call"
(SLT users)
Section 5-A-8.00 "Operator Call"
• Transfer
The extension user can transfer a call to the
operators (Attendant Console or Extension) by
both screened and unscreened call transfers.
For further information, refer to the following.
(PITS users)
Section 4-F-1.01 "Unscreened Call Transfer to
Station"
Section 4-F-1.02 "Screened Call Transfer to
Station"
Section 4-F-1.06 "Unscreened Call Transfer to
Attendant Console"
(SLT users)
Section 5-D-1.01 "Unscreened Call Transfer to
Station"
Section 5-D-1.02 "Screened Call Transfer to
Station"
Section 5-D-1.04 "Unscreened Call Transfer to
Attendant Console"
• Hold
The extension user cannot hold a call with an
attendant console operator.
— extension
extension ATT