Concluding Steps - Fujitsu PRIMERGY RX1330 M1 Upgrade And Maintenance Manual

Figure 127: Routing the BBU cable
Ê Route the BBU cable as shown in the figure.
9.5.1.4

Concluding steps

"Reassembling" on page 52
Ê
"Connecting the server to the mains" on page 55
Ê
"Updating RAID controller firmware" on page 74
Ê
"Enabling SVOM boot watchdog functionality" on page 78
Ê
"Switching on the server" on page 57
Ê
Note on BBU charging and calibration
The BBU may be deeply discharged due to extended storage time and wrongly
show as bad or defective in the ServerView RAID Manager. In this case, the
BBU will automatically enter a trickle charge cycle for recovery. This initial
charge may take up to 12 hours before the BBU will initiate a recalibration cycle.
Ê Enter the ServerView RAID Manager and check the current BBU status.
I
For further information, please refer to the "ServerView Suite RAID
Management" user guide.
RX1330 M1
Upgrade and Maintenance Manual
Expansion cards and backup units
191