Replacing A Riser Card; Preliminary Steps; Removing The Defective Riser Card - Fujitsu PRIMERGY RX1330 M1 Upgrade And Maintenance Manual

Expansion cards and backup units
9.4.4

Replacing a riser card

Field Replaceable Unit
(FRU)
Tools: Phillips PH2 / (+) No. 2 screw driver
9.4.4.1

Preliminary steps

"Locating the defective server" on page 43
Ê
"Shutting down the server" on page 45
Ê
"Disconnecting the server from the mains" on page 46
Ê
"Getting access to the component" on page 47
Ê
"Locating the defective component" on page 45
Ê
Ê Remove the corresponding riser module as described in section
riser modules" on page
9.4.4.2

Removing the defective riser card

Ê Remove the expansion card as described in section
expansion card" on page
Figure 109: Removing the riser card - example riser module 1
Ê Remove the two screws (1).
Ê Remove the riser card (2).
176
58.
172.
Upgrade and Maintenance Manual
Hardware: 5 minutes
"Removing the
"Handling
RX1330 M1