Installing The New 4 X 2.5-Inch Hdd Backplane - Fujitsu PRIMERGY RX1330 M1 Upgrade And Maintenance Manual

Hide thumbs Also See for PRIMERGY RX1330 M1:
Table of Contents

Advertisement

Hard disk drives / solid state drives
Right side 4 x 2.5-inch HDD backplane (A3C40157828)
Figure 61: Removing the 4 x 2.5-inch HDD backplane
Ê Disconnect all cables from the HDD backplane (see orange arrows).
I
If applicable, remove the OOB cable from the HDD backplane, too.
Ê Pull the HDD backplane upward until the four hooks disengage (see circles).
Ê Take out the HDD backplane.
7.2.8.3

Installing the new 4 x 2.5-inch HDD backplane

I
For configurations with up to four 2.5-inch HDDs/SSDs, please refer to:
section
"Left side 4 x 2.5-inch HDD backplane (A3C40157852)" on
page
129.
For configurations with up to eight 2.5-inch HDDs/SSDs, please refer to:
section
"Left side 4 x 2.5-inch HDD backplane (A3C40157852)" on
page 129
or
page
131.
128
"Right side 4 x 2.5-inch HDD backplane (A3C40157828)" on
Upgrade and Maintenance Manual
RX1330 M1

Advertisement

Table of Contents
loading

Table of Contents