Table of Contents
Advertisement
Figure 11: Example: Locking the cable clamp of a power supply unit
Ê Pull the cable clamp up (1).
Ê Thread the power cord through the cable clamp (2).
Ê Press the cable clamp down until it engages to secure the cable (3).
4.7
Switching on the server
V
CAUTION!
Before switching on the server, make sure the top cover is closed. In
●
order to comply with applicable EMC regulations (regulations on
electromagnetic compatibility) and satisfy cooling requirements, the
server must not run while the top cover is removed.
For further safety information, please refer to chapter
●
information" on page
Ê Press the On / Off button to start up the server.
Ê Ensure that the power-on indicator above the On / Off button is lit green.
Ê Perform the required procedures described in the concluding steps of each
upgrade or maintenance task.
RX1330 M1
31.
Upgrade and Maintenance Manual
Basic hardware procedures
"Important
57
Advertisement
Table of Contents
