Preliminary Steps; Removing The Heat Sink - Fujitsu PRIMERGY RX1330 M1 Upgrade And Maintenance Manual

11.2.1 Preliminary steps

"Locating the defective server" on page 43
Ê
"Disabling SVOM boot watchdog functionality" on page 64
Ê
"Suspending BitLocker functionality" on page 63
Ê
"Shutting down the server" on page 45
Ê
"Disconnecting the server from the mains" on page 46
Ê
"Getting access to the component" on page 47
Ê
"Removing a riser module" on page 58
Ê

11.2.2 Removing the heat sink

Figure 142: Removing the heat sink
Ê Loosen the four screws of the heat sink in a crossover pattern according to
the numbering.
Ê Carefully turn the heat sink back and forth to detach it from the processor.
I
This may be necessary due to the adhesive quality of the thermal
paste located between the heat sink and the processor.
V
CAUTION!
Pay special attention not to damage any system board components
surrounding the processor socket.
Ê Lift the heat sink out of the chassis.
RX1330 M1
Upgrade and Maintenance Manual
Processor
215