Installing The Front Panel Module - Fujitsu PRIMERGY RX1330 M1 Upgrade And Maintenance Manual

Ê If applicable, remove the front VGA board with the front VGA connector as
described in section

13.2.1.3 Installing the front panel module

Ê If applicable, install the front VGA board with the front VGA connector as
described in section
Figure 169: Connecting cables to the front panel module
Ê Connect the front panel cable (1).
Ê Push the front USB connector in the corresponding recess and fasten the
front USB cable with two screws (2).
Ê If applicable, connect the front VGA cable to the front VGA board (3).
I
If the VGA cable was secured with a cable tie, secure the VGA cable
with the cable tie.
RX1330 M1
"Removing the front VGA board" on page
"Installing the front VGA board" on page
Upgrade and Maintenance Manual
Front panel
244.
242.
239