Removing The Defective 3.5-Inch Hdd Module; Installing The New 3.5-Inch Hdd Module; Concluding Steps; Replacing The 3.5-Inch Hdd Backplane - Fujitsu PRIMERGY RX1330 M1 Upgrade And Maintenance Manual

7.3.4.2

Removing the defective 3.5-inch HDD module

Ê Remove the HDD module as described in section
HDD module" on page
7.3.4.3

Installing the new 3.5-inch HDD module

Ê Install the HDD module as described in section
module" on page
7.3.4.4

Concluding steps

"Performing a RAID array rebuild" on page 85
Ê
7.3.5

Replacing the 3.5-inch HDD backplane

Field Replaceable Unit
(FRU)
Tools: tool-less
7.3.5.1

Preliminary steps

"Locating the defective server" on page 43
Ê
"Shutting down the server" on page 45
Ê
"Disconnecting the server from the mains" on page 46
Ê
"Getting access to the component" on page 47
Ê
Ê Release all HDD modules and pull them out a few centimeters, see section
"Removing a 3.5-inch HDD module" on page 145
I
The HDD modules need not to be removed. But if you want to remove
them nevertheless, check if all HDD modules are uniquely identified
so that you can reinsert them into their original bays.
7.3.5.2

Removing the defective 3.5-inch HDD backplane

Ê Disconnect all cables from the HDD backplane.
RX1330 M1
145.
143.
Upgrade and Maintenance Manual
Hard disk drives / solid state drives
"Removing a 3.5-inch
"Installing a 3.5-inch HDD
Hardware: 10 minutes
147