Table of Contents
Advertisement
Power supply
Figure 44: Connecting the power cables to the system board
Ê Connect the two power cables to the system board connectors "P30" and
"PWR1".
Installing hot-plug power supply unit and dummy cover
Ê Install the power supply unit as described in section
power supply unit" on page
I
The power supply unit must be installed in the first bay (left bay seen
from rear side). The dummy cover must be installed in the second
bay.
Ê Install the dummy cover as described in section
on page
103.
112
98.
Upgrade and Maintenance Manual
"Installing a hot-plug
"Installing the dummy cover"
RX1330 M1
Advertisement
Table of Contents
