Hard disk drives / solid state drives
Ê Connect the SAS cables:
The shorter SAS cable connected to HDD backplane (A3C40157828) to
connector "MLC1" of the dual-channel RAID controller (1)
The longer SAS cable connected to HDD backplane (A3C40157852) to
connector "MLC2" of the dual-channel RAID controller (2)
Figure 75: Routing SAS cables
Ê Route the SAS cables as shown in the figure above.
7.2.11.3 Installing additional HDD/SSD modules
Ê Remove the dummy locks as described in section
HDD/SSD dummy module" on page
Ê Move the HDD/SSD modules installed in the former HDD bays 1 to 4 (see
figure 48) to the new HDD bays 1 to 4 (see figure 50).
Ê Insert additional HDD/SSD modules as described in section
inch HDD/SSD modules" on page
7.2.11.4 Concluding steps
"Reassembling" on page 52
Ê
"Connecting the server to the mains" on page 55
Ê
"Switching on the server" on page 57
Ê
"Performing a RAID array rebuild" on page 85
Ê
140
MLC 2
MLC 1
Upgrade and Maintenance Manual
"Removing a 2.5-inch
120.
120.
"Installing 2.5-
RX1330 M1