Concluding Steps - Fujitsu PRIMERGY RX1330 M1 Upgrade And Maintenance Manual

Right side 4 x 2.5-inch HDD backplane (A3C40157828)
Figure 64: Installing the 4 x 2.5-inch HDD backplane
Ê Position the HDD backplane on the four hooks (see circles).
Ê Push the HDD backplane downward. Make sure that the lower cant of the
HDD backplane fits in the guides (A).
V
CAUTION!
Ensure that none of the cables are strained or damaged!
Ê Connect the following cables to the HDD backplane:
– (1) SAS cable to connector "X5" on the HDD backplane
– (2) power cable to connector "PWR" on the HDD backplane
I
If applicable, connect the OOB cable to connector "SMBus" on the
HDD backplane.
For the cable plan see section
7.2.8.4

Concluding steps

Ê Insert all HDD/SSD modules, see section
modules" on page
I
Make sure that you reinstall the HDD/SSD module in the bay it was
located before the HDD backplane replacement.
"Reassembling" on page 52
Ê
"Connecting the server to the mains" on page 55
Ê
"Switching on the server" on page 57
Ê
RX1330 M1
"Cabling" on page
120.
Upgrade and Maintenance Manual
Hard disk drives / solid state drives
285.
"Installing 2.5-inch HDD/SSD
131