Table of Contents
Advertisement
Hard disk drives / solid state drives
7.3.4
Replacing a 3.5-inch HDD module
Customer Replaceable Unit
(CRU)
Tools: tool-less
V
CAUTION!
Only remove an HDD module during operation if the drive is not
●
currently being accessed. Observe the indicators on the HDD
module, see section
page
309.
Under no circumstances should you remove an HDD module while
●
the system is in operation if you are not sure that the drive is operated
by a RAID controller and belongs to a disk array that is operating in
RAID level 1, 1E, 10, 5, 50, 6 or 60.
An HDD module can only be replaced during operation in conjunction
with a corresponding RAID configuration.
All HDD modules (drives) must be uniquely identified so that they can
●
be reinstalled in their original bays later. If this is not done, existing
data can be lost.
7.3.4.1
Preliminary steps
"Locating the defective server" on page 43
Ê
"Locating the defective component" on page 45
Ê
Only applicable for removing intact HDD modules:
Ê Before removing a non-defective HDD module, put the drive into "Offline"
mode using your RAID configuration software.
I
For further information, please refer to the "ServerView Suite RAID
Management" user guide.
146
"Indicators on the hot-plug HDD module" on
Upgrade and Maintenance Manual
Hardware: 5 minutes
RX1330 M1
Advertisement
Table of Contents
