Preliminary Steps - Fujitsu PRIMERGY RX1330 M1 Upgrade And Maintenance Manual

System board and components

14.6.1.1 Preliminary steps

"Locating the defective server" on page 43
Ê
"Note on network settings recovery" on page 277
Ê
"Disabling SVOM boot watchdog functionality" on page 64
Ê
"Suspending BitLocker functionality" on page 63
Ê
"Shutting down the server" on page 45
Ê
"Disconnecting the server from the mains" on page 46
Ê
Ê Disconnect all external cables.
"Getting access to the component" on page 47
Ê
Ê Remove all memory modules, see section
page 211.
I
Before removing the memory modules, take a note on the installation
slot number for each memory module. Make sure that you reinstall
the memory modules in the slot they were located before the
replacement.
Ê Remove the heat sink, see section
Ê Remove all expansion cards, see section
on page 170.
I
Before removing the expansion cards, take a note on the installation
slot number for each card. Make sure that you reinstall the card in the
slot it was located before the replacement.
Ê Remove the UFM (if applicable), see section
on page 259.
I
Remove the UFM spacer from the defective system board and fasten
it with the UFM screw to the UFM board.
Ê Remove the iRMC microSD card (if applicable), see section
iRMC microSD card" on page
278
"Removing the heat sink" on page
273.
Upgrade and Maintenance Manual
"Removing a memory module" on
"Expansion cards and riser cards"
"Removing the defective UFM"
215.
"Removing the
RX1330 M1